TECHNOLOGY

Topology:
Feedback:
Mass Centering:
Leveling:
Alignment:
 

Symmetric tri-axial
Force balance with capacitive displacement transducer
Automatic mechanical re-centering can be remotely initiated 
Integrated bubble level, adjusted locking leveling feet
Vertical scribe marks for E/W, precision holes for 5/16" alignment rod for N/S

PERFORMANCE

Noise:
Passband:
Clip level:
  Temperature:
Velocity:

 Below the NLNM from 100 seconds to 10 Hz 
Flat to velocity from 240 seconds to 35 Hz
> 15 mm/s up to 1.5 Hz 
±10°C without re-centering
1200 V*s/m standard velocity

ANALOG INTERFACE

Velocity Output:
Mass Position:
Mass Centering:
Calibration:
 

40 V peak-to-peak differential, selectable XYZ or UVW mode
Three independent voltage outputs
Single 5 V active-high control
Single voltage input with one active high control signal per channel; remote calibration in XYZ or UVW

DIGITAL INTERFACE

Type:
With Access To:
 
 
 
 
 
 
 
 

Serial RS-232 compatible interface for state-of-health, command and control
Mass position display
Mass centering command
UVW/XYZ mode command
Long/short period mode command
Temperature: current, min/max since reset
Stepper motor position: current, min/max since reset
Factory calibration data
Instrument ID information

POWER

Supply Voltage:
Power Consumption:
Protection:
 
 

9-36 VDC
650 mW typical at 15 VDC input
Reverse voltage protected
Auto-resettable over-current protection
No fuse design

PHYSICAL

Connector:
Diameter:
Height:


Weight:
Parasitic Resonance:

19 pin MIL-C-26482, mounted on base
25 cm
26.5 cm without leveling feet
28.6 cm with leveling feet at minimum extension
29.5 cm with leveling feet at maximum extension
14 kg
None below 150 Hz

ENVIRONMENTAL

Operating Temperature:
Humidity:
Shock:
 

-20°C to +50°C
0-100%
20 g half sine, 5 ms without damage, 6 axis
No mass lock required for transport